BOSCH BL2191 1 In. x 6 In. Frazzjonali mnaqqsa Shank Iswed Drill Bit

Name: BOSCH BL2191 1 In. x 6 In. Frazzjonali mnaqqsa Shank Iswed Drill Bit
Brand: BOSCH
SKU: 0000346332360
Availability: InStock

Brand:BOSCH

3.2/5

€

Għall-użu fl-azzar, ram, aluminju, ram, ballut, aġġru, MDF, arżnu, PVC, polikarbonat, akriliku, ABS, najlon u materjali komposti. Disponibbli f'tul jobber, tul stubby, tul estiż (inġenju tal-ajru), 1/2 In. qasba mnaqqsa (Silver u Deming). Tħaffir aktar faċli, sħana mnaqqsa u ħajja estiża tal-bit drill. L-aħħar 50 fil-mija itwal mill-azzar b'veloċità għolja. Disinn tal-helix tal-veloċità għal tħaffir tliet darbiet aktar mgħaġġel minn bits standard.

Ammont

Żid mal-CART Ixtri issa

EAN: 0000346332360

Kategoriji Għodda tal-Enerġija u tal-Idejn, Power Tool Partijiet u Aċċessorji, Power Drill Partijiet u Aċċessorji, Drill Bits, Twist Bits, Jobber Drill Bits,

Brand	BOSCH
Finish Type	Black Oxide
Material	Brass
Shank Type	Straight
Tool Flute Type	Spiral

5 Star

4 Star

3 Star

2 Star

1 Star

Ikteb ir-reviżjoni tiegħek

L-email tiegħek mhux se tiġi ppubblikata. L-oqsma obbligatorji kollha huma mmarkati bi^*

Il-klassifikazzjoni tiegħek

Scritto da: Jack

Heavy duty drilling in steel

Yes, does a fantastic job, even in hardened cast-iron. I found that a 350 rpm setting on your heavy duty drill press is perfect.

Scritto da: opinions are like A_ _ holes

sharp

this is a good quality drill bit. it cuts great and seems to stay sharp. i always use cutting oil so im sure that helps as well

Scritto da: Damon

Just as the doctor ordered

Needed a 1" drill bit to drill through Robinson's decking after pilot hole. Works great.

Scritto da: WBS

Not for heavy duty use

I knew it was HSS black oxide and not Cobalt but I only needed to widen 8 holes from 7/8 inch to 1 inch in 1/4 hard steel. Got four done but last one was extremely hard to do. Not sure now whether the bit will handle soft metal.

Scritto da: Paul Vitolins

Cuts like a champ. As one would expect from Bosch

Cuts well and stays sharp! Very satisfied. Thanks!

Scritto da: notme

so far so good

drilled a few holes with it, only thing I don't like is it would be better if the shank had 3 flats.....

Scritto da: Ronny Dwiputra

CAN DRILL 1" THICK OF STEEL

So I used this drill bit with some lubricant to extend the hole of my trailer hitch from 3/4" to 1". It's like drilling 1"-1-1/2" thick of steel. I took me like 20 mins of drilling, but it works, even just with my cheap RYOBI drill.